The Printables listing for the SV06 and SV06 Plus seem to suggest that the Prusaslicer profile is already setup when using the 3DClippy. However, as the tool change gcode sits, it never triggers the "button" and never loads the filament. The SV06 Plus flag bearing housing is located on the back left and the button is triggered at Y300. No matter what you put in the folllowing line (G0 X20 Y217 F2000 ;   <<-----  EDIT THIS LINE TO SET THE INITIAL LOCATION OF THE BUTTON - note the new X for holding for cut), it never hits the button. Print starts with no filament loaded.

What did everyone put for extruder to hotend distance....like 30mm?