It does move away and then does this....Then, when the print starts, it waits at the Y297 hold position and then hits the switch (pausing for 3 seconds), the 3D Chameleon stepper(s) grinds and the filament never loads. It doesn't seem like it likes the 3-second pause. During a print, the filament never loads. However, if I am running through testing...it loads just fine.

Updated to Y297. During the G29 bed probe the last row holds the switch at Y300 during the last 5 probes. Then, when the print starts, it waits at the Y297 hold position and then hits the switch (pausing for 3 seconds), the 3D Chameleon stepper(s) grinds and the filament never loads. It doesn't seem like it likes the 3-second pause. I can get it to load when testing.

When testing, filament loads on all four colors. My issue now is that the print starts and never hits the button to load filament. Using the 3DClippy on SV06 plus with flag bearing housing on the left rear. Using the Prusaslicer profile from Printables. However, once the print starts, it never hits the button to load the filamament. In the following line, G0 X20 Y217 F2000 ;   <<-----  EDIT THIS LINE TO SET THE INITIAL LOCATION OF THE BUTTON - note the new X for holding for cut, should the Y position be Y300 since that is the position where the button is triggered? Tried that but it still never triggers. Print starts with out filament loaded. Also, during bed probe, the last row triggers the button during all final probes. Not sure if that is causing an issue.

Disregard, found the gear. Took it apart and reinstalled the gear and grub screw. Seems to be working.

So, I just got everything installed and loaded filament. Went to run the test instructions and that is when it went bad. The Chameleon made an aweful grinding sound and parts fell out. I found a small grub screw but it appears as though a bearing or gear or something fell out that I have been unable to find. Left side.

The printables page mentions having the flag bushing part on the left rear of the bed.

I just noticed something. For the SV06 Plus, the button goes on the back left versus the front?

Ah, that makes sense. Yes, I am using the 3DClippy. Thanks!