I installed 3D Chameleon Mk3 on my Prusa MINI+ with the help of YouTube videos and information from Printables. The mode is set to Direct Drive Mode. reference1: https://youtu.be/fdfgv_ZD5cM reference2: https://www.printables.com/model/48846 print data: https://www.tinkercad.com/things/hgYyl62dCqL I have tested loading with PETG filament @220-250℃. It feeds it smoothly until the filament reaches the nozzle, but once it reaches the nozzle it is not feeding the filament well, perhaps due to weak tension in the gears and bearings. What should I do to solve this? E-step is set to the recommended value of 152 for this thread (and for other settings as well). https://www.3dchameleon.com/forum/support/prusa-mini-cannot-print-even-with-single-color Any advice would be appreciated.