I have recently purchased a 3d chameleon for installation on the sv06 plus. I had a few questions surrounding the setup. Per previous forum post, i have gone ahead and changed the y axis gcode in the toolchange section from 217 to 297 as well as to 300 for the switch impact. I have verified that the bed impacts this switch when it moves to 300. Now I assumed that we are given a large amount of PTFE tubing and are expected (again assuming) to cut it to length for our appropriate printer? I have not seen this stated in any of the forum posts (I could have missed this in my searching). Per the picture below, I have it installed on the plus. However, am i in correct in assuming that the 3dchameleon and ptfe tube should lead straight to the hole and not be forced in at the angle you see in the picture? Currently, i would have to sand down the zip tie connection location in order for the green tube to sit in a more appropriate vertical position. So to sum up? Am i to cut the ptfe tubing from the motor going into the green piece to length ? Also is the current installation per the picture below correct? Or should i look at sanding down the y joint that holds the dark green plastic piece in place?