I set up my 3d Chameleon yesterday and everything seems to be working except I have to manually push the filament after clippy for the extruder to catch the new filament. I am using the profile from printables and I am in MODE 2. I have ensured that the blade is completely clear before the change, per another post. I am sure that it is a user error but figured I would post here for advice. Thanks
Matt
Bill,
Still no luck with MODE 3 profile. The filament doesn't load on second call. Switch is located at Y220 but parks at Y217 to load filament. I have tried editing the changer code to Y220 where my switch is but no luck there either. Any suggestions?
Matt
Thanks for the update, I will update the profile and give it a try. I will report back if I have any questions. Thanks for the response.
No, it's not user error, Sovol changed their design of the extruder and you need to use Mode 3 to get it to move the filament a little farther (about 1" farther.)
There is an additional profile on the Printables page that already has those changes in it.
https://www.printables.com/model/371141-3dchameleon-mk3-mounts-for-the-sovol-sv-06-and-plu/files
Bill