Forum Posts

Zeke Ahern
May 03, 2022
In Support
I have never had any success. Tried just one colour, 1 filament is loaded into the chameleon. It prints the first layer, but that's about it. I think it's cause maybe the filament switching gradually becomes weaker and can't drive the system. I'm using a prusa mini btw with prusa slicer 2.3.3 cause the reversedrive doesn't like the temp files in 2.4.1 or 2.4.2.
0
1
44
Zeke Ahern
Apr 30, 2022
In Support
I was wondering if you could provide more pictures of a prusa mini 3d chameleon set up. I followed all the instructions, but it doesn't seem to work. It hits the sensor and looks like it would change. But with my motor attached to it (from the prusa) it doesn't drive anyfilament through the system at all. Just would love to see some close up pictures just so I know If I have everything set up the right
0
3
69
Zeke Ahern
Apr 02, 2022
In Support
I get this error with the test file Bill provided. I have changed the dependency to my drive so it should be able to read the reverse.py. However I get this error in the screenshot. Anyone else encounter this?
0
6
50

Zeke Ahern

More actions
GreenLogoNoText.png