Well, at least my failure can help someone else. 😁

I used your tool change g-code, and removed the extra code from the filament section. Now I just need to get all of my slicer setting dialed in.

Thanks. I found this and deleted it.

This might be a silly question, but what should the "g-code flavor" be under Printer Settings/General? I feel like I researched this at one point for the K1 Max, and Creality said to use Marlin, but mine is currently set to "Klipper".

I will lower the load time slightly. I printed bearing spacers last night for lower tension, and now it does move relatively freely after loading. (That wasn’t exactly the case before swapping those.) The following result was the same as the video I shared. The cam does go to the correct positions. I did see your guide, and it makes me very hopeful. lol. I will do a side by side comparison of your gcode and mine to see if anything jumps out. I appreciate the quick responses and helpful suggestions.

I have used a different profile on Prusa and it works fine. I will dig into the gcode shortly and see what I find.