top of page
Forum Posts
marcusg101
Nov 22, 2024
In Getting Started
I'm setting up an Ender 3 with the non-auto Clippy. I'm not great with G-code, and despite searching extensively, I haven't found any good examples of how to use it. Can anyone share some examples of how they've used it in their G-code?
0
1
76
marcusg101
Nov 07, 2024
In Getting Started
So I've ordered a mk4 and it should be here soon, Im modifying my ender 3 to be a lot larger (500 x 500) so I figured I'd add 3d chameleon with the 3d clippy. So since I'm doing all of this I may as well upgrade the hot end and extruder.
What hot end / extruder would you use for this set up?
0
0
48
marcusg101
Nov 27, 2022
In Support
No matter what I do this thing keeps sending either the left or right side filaments in together, causing a jam in the Y adapter, which causes the brass fitting to pop off inside of the fimalmet loader. I cant use this at all. I've taken it apart and I don't see anything that could be causing it. There is lack of any proper documentation so troubleshooting is mostly guess work. Hell I don't even know what extruder is considered T0. This has taken up way too much of my time all for one 2 color calibration cube that I was able to print, and that came out like garbage. Did I just throw away my money and time?
0
4
117
marcusg101
Nov 14, 2022
In Support
Hi, I just finished putting together my new kit. I was trying to get ity loaded and I think it jammed wich made the tube pop out of the motor housing. Is there a good video on taking one of these apart? I saw one where it was being built, but Im worried that I may break something so Id like to see if there is a procedure. What are the fittings called and what size are they, so I can get some replacements? Also is there a cheat sheet with the commands so I can load it without a lot of guesswork and or running to my PC trying to parse out what does what?
0
6
105
marcusg101
More actions
bottom of page