I would like to potentially get the 3d Chameleon but I want to have it and the Bambu AMS be available to be used with just a selection of one printer profile or the other. At this point I haven't seen this configuration yet. I would like to be able to print with TPU using the 3d Chameleon and use the AMS for any thing else I have loaded up. I not asking if I can use the AMS and the Chameleon on the same print, I can see where that might be a little more difficult or not possible at this point in time. Has anybody used the Chameleon for TPU? I saw a comment from Bill that it should be able to, but I haven't seen it in use. My limited experiance with TPU has demonstrated it only takes a small amount of drag before the extruder for the print to fail from under extrution from the extra drag.