Well, it didn't go as well as I was hoping.
I think my bug is in the TOOL CHANGE GCODE....
But here's my workflow on my Rooted K1 Max.
I'm trying to print the 3DChameleon Keychain cause its something like 50 color swaps and the slicer tells me that it should take an hour or so a good candidate for a first test :)
I send the print directly from within Orcaslicer 2.0.0- Beta
Extruder is NOT loaded when I send the file.
So after the adaptative bedmesh, the hotend goes on the button and after the initial homing of the Chameleon. T0 is loaded succesfully in the extruder with minimal grinding from both, the Chameleon and the extruder.
Start to print just fine, but it does a bit of the first color for the 1st layer, then moves to the purge block, finishes with T0. and after that...
Goes to hold the button for WAY to long witch result in something like 50 pulses on the chameleon, while its doing what I believe to be the tip shaping, but never manage to back T0 out of the extruder.
So I stop it there after confirming that its still printing with T0...
My resoning is that my switch coordonates and my timing to the extruder are good since it manages to load T0 with the Start gcode.
I've spent a while figuring out the timing to load the extruder.
But maybe its my UNLOAD time that's mesed up or something in the Orcaslicer toolchange gcode that's funky.
I don't know.
what should I be cheking next ?
Thanks for your help
Jo