Disregard. found on printables.

Hey Robert. Fellow P1P user here. Bill's newest Printables P1P configuration works as you want it too. The splitter gets put at the stock filament loader. You get all filaments loaded to the y-split, and upon printer start it will load filament 1, and begin print. And on changes will unload and load the next. Ive had 3 successful prints with the newest config.

Looking forward for the video update as well. Thinking about grabbing a second 3DC.

Hey, just an update. Bill published a new P1P profile on his printables which works much better. It is meant to run with your 4-way splitter right at the P1P filament feed at the back. Have all filaments at the start of the Y. Upon starting a print, the 3DChameleon will select and feed filament #1 in. Also, i posted an update top his settings that he emailed me when he was helping me trouble shoot. My cutter was getting jammed, so he sent me these two lines to add in under the "filament change" section of your printer. Ive had 3 successful prints now with my P1P and the 3D Chameleon.

Try the incognito / private modes of the browsers to see if it works. My chrome went back to not working unless in the Incognito mode for some reason. But my EDGE has worked no issues in regular mode.

Just adding in here to see what the resolution is. Just got my Chameleon as well, and not really versed in the lingo / Gcode commands. Is there an exact command to do it? thanks.

I cleared all my cache and browsing history and it loaded fine in chrome now. Not sure what triggered it initially though.

I had issues as well with chrome regular and incognito. So I tried Microsoft EDGE Browser and that generated the GCODE for me.

Is there a detailed instructional video or written directions with installing and GCODE commands to use the clippy?