All sorts of issues on Mk4
I bought a Mk4 back in April because I thought it'd be a cheaper alternative to the Bambu AMS, initially I was having trouble with installation so I gave up. Over the last couple of days, I've been trying to push through this painful setup on my P1S, and I've got everything supposedly correct, except it will not ever just move one filament. If it's pushing T0 in, it's pulling T2 out. Same with T1 and T3. Kind of at the end of my rope here. Any ideas?
95 Views
Cross talk (when two filaments move when only one is commanded) happens when the selector cam isn't lined up correctly. Make sure it's homed first and that it's aligned to the 0, 90, 180 and 270 degrees positions correctly when they're selected and that the bearings are fully seated onto the cam.
Bill