Support

Printer: K1 speedy

The issue:

After configuring the gcode to move to the button and entering the correct values x/y it does not appear to work properly.

What happens:

The printer does the normal start gcode, auto bed level, heats up etc. When it goes to touch the button, it does 3 quick button presses, lets off for a moment, then presses and holds for a really long time. I can hear the cameleon ticking, but no filament is loaded or unloaded. Then the print head moves off as if it starts the print. I made sure that the cameleon is on mode 3, its homed properly before the print starts. If I manually press the switch I can successfully load/unload filament in the right directions. What am I doing wrong?

Heres my start gcode:

SET_FILAMENT_SENSOR SENSOR=filament_sensor ENABLE=0

SET_FILAMENT_SENSOR SENSOR=filament_sensor_2 ENABLE=0

M82 ;absolute extrusion mode

START_PRINT EXTRUDER_TEMP=[first_layer_temperature] BED_TEMP=[first_layer_bed_temperature]

G92 E0

; 3DChameleon Preload Extruder 1

; load filament 1 to extruder

G0 X206 Y216 F10000 ; move to button

; three quick button presses to cancel out any active commands

G0 Y219 F2000 ; press button

G4 P150 ; wait for 150 ms

G0 Y215 F2000 ; unpress button

G4 P150 ; wait for 150 ms

G0 Y219 F2000 ; press button

G4 P150 ; wait for 150 ms

G0 Y215 F2000 ; unpress button

G4 P150 ; wait for 150 ms

G0 Y219 F2000 ; press button

G4 P150 ; wait for 150 ms

G0 Y215 F2000 ; unpress button

G4 P150 ; wait for 150 ms

G0 Y219 F2000 ; press button

G4 P3200 ; wait for 7 pulses

G0 Y215 F2000 ; unpress button

G4 P2000 ; wait for it to home

; select T0

G0 Y219 F2000 ; press button

G4 P550 ; wait for 550 milliseconds

G0 Y215 F2000 ; unpress button

G4 P2000 ; all done

; load T0 for 28 seconds and into extruder

G0 Y219 F2000 ; press button

G4 P20000 ; wait for 27 seconds

G0 E50 F500 ; <<<--- adjust this E value to tune extruder loading

G0 X220 Y210 Z.2 F1000; move to extruders assigned purge line

G0 Y0 E60; purge the extruder.

G0 X219; purge the extruder.

G0 Y200 E105; purge the extruder.

G4 P2000 ; all done

SET_FILAMENT_SENSOR SENSOR=filament_sensor ENABLE=1

SET_FILAMENT_SENSOR SENSOR=filament_sensor_2 ENABLE=1