top of page

Support

Public·40 members

MK3 code + 3dclippy code help required

Hi all,

I've managed to successfully upgrade my 3DChameleon firmware to the MK3.1, and I have also now successfully printed and installed my 3dclippy but i need a little advice on the following topics regarding the MK3 GCode that is automatically generated:-


My 3dclippy will CUT at X=220, then can be reset by sending the print head to X=0, but I've no idea, whereabouts in the automatically produced Gcode from the site as to where to put this, nor (at the moment - but I will research after posting this) the actual Gcode commands to make the two above movements.


Many thanks - looking forward to trialling and getting the colour flowing reliably, so any further advice (using an S1PRO) greatly received !! :)


Colin.





192 Views

Hi Bill,


As suggested, Sent an email, pictures, video and gcodes - please confirm receipt?


Best regards,


Colin.

About

Need help... check out this thread for advice from the exper...

Members

  • mayuri kathade
    mayuri kathade
  • Stan P
    Stan P
  • Ben Conner
    Ben Conner
  • Lopp Klopp
    Lopp Klopp
  • BOSS SUB
    BOSS SUB

For the latest information on product availability, be sure to follow us on twitter!  @3DChameleon

For more installation videos, be sure to follow us on Youtube!

  • Facebook
  • Twitter
  • YouTube

©2023 by 3D Chameleon

bottom of page