Hey folks, I can’t find a good mount for the ender 3 v2 due to how little space between the extruded and the Z axis pipe. Any help would be appreciated
top of page
bottom of page
Hey folks, I can’t find a good mount for the ender 3 v2 due to how little space between the extruded and the Z axis pipe. Any help would be appreciated
My solution to this problem, I did not like how tight the bend was when I rotated the extruder.
What happens when you rotate it 90 degrees? (Also, it looks like your drive gear is pretty chewed up... might want to replace that if it is.) For reference, here is a pic of my Ender 3 V2... note that I upgraded to the BMG clone and it works wonderfully. (Also note that I used a Right hand version of the extruder to make sure the tube was farther away from the z rod... the stock drives the filament from the left side of the drive gear, which is the primary issue.) Those plastic Ender extruders fail very often due to the plastic breaking... it's not matter of if, but when... for $15, the BMG is a great and inexpensive upgrade.
Bill