Has anyone set up their 3DC with an Ender 3 S1 Plus with the 300x300x300 print bed? I've tried placing it at the front of the Y Axes but it's at the 285 point and causes the print bed to jam into it when doing things like ABL.
top of page
bottom of page
Actually, Steve Pax did one for the Ender 3 S1 Pro, which should work just fine for yours as well. Here's his: https://www.thingiverse.com/thing:5643724 As an alternative, the Mk2 and Mk3 also allow the button to be replaced with a digital signal. The Ender series of main boards actually have two different Z probe interfaces... and depending on which one you have, you can use the one they're not using. To trigger it, you'd simply use the M42 Gcode command instead followed by the proper delay. Bill