I was thinking about bypassing onboard manufactures extruder (ENDER) and letting the Chameleon connect directly to the "HOTEND" . Is there any addition or subtractions from GCODE scripting that I need to be aware of ?
That is not a feature that is supported anymore. The software to set it up is too difficult. The ability to set it up that way was removed from the Mk3 firmware. I do have plans to add a similar feature in the future (it's in the works for the Mk4 firmware), but it's not ready yet.
thanks for the update Bill !
That is not a feature that is supported anymore. The software to set it up is too difficult. The ability to set it up that way was removed from the Mk3 firmware. I do have plans to add a similar feature in the future (it's in the works for the Mk4 firmware), but it's not ready yet.
Bill