Just getting started with my 3d Chameleon and changing is finally happening with little effort (still need to tune a little bit). When I color change, after clippy, it goes to the back of the printer, creates a blob, and then continues to the purge tower. I have found that I always have to remove the blob or it drags over the purge tower and pull the blob and filament into the print. Once the several layers of the purge tower are gone, it requires constant removal for each color change later. Does the blob have to be done if you have you have a purge tower? Thanks
Matt
You need to tune the load... There is a line in the tool change code that tells you what to adjust to do the blobbing.
Bill