I received my kit. I watched the videos and read the instructions but I have questions. Some of the instructions and videos do not cover the operation fully.
How do I load filament accurately to stop just above each of the four chameleon inlets? I understand the settings from that point to the extruder gear but with accurate loading, how is it possible to be consistent? I can shove a filament into the stepper assembly at random lengths. How would an typical operator (my wife) change colors correctly?
Can I cut the four lines to the chameleon? They are way too long.
Do I have to operate the switch to load the four filaments?
Also, can you point me to a diagram of the chameleon tube inlet numbers? I want to make sure I got 1,2,3,4 in the correct place.