I've updated the firmware from Mk3 to Mk4, and added the OLED display. I'm getting unexpected results when pressing the switch. More often than not, when I press the switch, I get a "No Command" response on the display. It then displays "Clear", and finally it displays "Idle" a few seconds later.
Aside from that, I can only seem to get it to go to T0 one of ten times, if that. No matter how long I hold the switch, that is all I can ever get most of the time. Several times I get a message "Press to load T0", or "Press to unload T0", and then it may show "Cutting". Not sure why it would show cutting if I don't yet have the servo attached.
I'm not sure what I'm doing wrong, so any ideas would be helpful.
Feeling pretty confused. 😥
It sounds like the clock wasn't set properly using the Bootloader. Just try to reinstall it again, but make sure the Bootloader is successful before trying the firmware.
Bill