Hi, I'm trying to build a cutter with servo mounted on X axis motor triggered by 3D Chameleon. I try to keep printhead as light as possible. But I see servo is being turned by about 30 or 40 degrees. If it could be turned by 90 degrees it could solve my problem. Please!
@topchiyev That design looks like it might be a good start for my setup. Would you mind sharing the file? I am going to build a setup that works for the older style Micro Swiss direct extruder. It has about a 1 inch open gap between the extruder the the top of the cooling block so I need a narrow setup. I'd be grateful. Thank you.