IMPORTANT UPDATE!

The forum that was previously hosted on Wix is now being moved to Github. We will maintain this for future information only and posting or editing is being disabled.

Go to Github Discussions Page

To see this working, head to your live site.

robert taggart

Jul 14, 2024

Filament is not getting into the bottom bowden tube connector in the y adapter. Tried T0,T1,T2, and T3. Hasn't been in extruder yet.

in Support

2 comments

2 Comments

wjsteele

Jul 14, 2024

Is the PTFE tube fully inserted into the pocket above the connector? It needs to fully seated or then filament can catch on the edge. Also, make sure the inside of it is flared to act as a guide or funnel into the tube.

Bill

robert taggart

Jul 14, 2024

Replying to

I shortened all the PTFE tubes and re-seated them and flared. I am now able to push past the connector.