The forum that was previously hosted on Wix is now being moved to Github. We will maintain this for future information only and posting or editing is being disabled.
At this point, no. However, stay tuned for the Mk4 firmware... it will have a couple of facilities to speed it up, including ramping up the speed of movements.
What I would say at in the Mk3 firmware, the best way to speed it up is to shorten the distance between the Y adapter and the extruder. I prefer to have the Y adapter right at the exruder, which will allow you to get color changes down to just about 15 seconds. For every inch away from it, you add 2 seconds of time.
Well, that's what Mode 3 does by default. You enter that distance into the GCode Generator as the "Backout Distance in Seconds." Basically, 1 second per 2.5cm or 1 inch.
At this point, no. However, stay tuned for the Mk4 firmware... it will have a couple of facilities to speed it up, including ramping up the speed of movements.
What I would say at in the Mk3 firmware, the best way to speed it up is to shorten the distance between the Y adapter and the extruder. I prefer to have the Y adapter right at the exruder, which will allow you to get color changes down to just about 15 seconds. For every inch away from it, you add 2 seconds of time.
Bill