The forum that was previously hosted on Wix is now being moved to Github. We will maintain this for future information only and posting or editing is being disabled.
ok so i think i will have to change the firmware with my vyper because i dont see nothing in cura for a tool change gcode in my settings, Also the bracket for the tube i dont have that same setup for my vyper,
No... the profile needs 4 extruders... not the printer. See my above answer... download my profile, which already has 4 defined, and modify the printer settings to match your Vyper printer.
to make sure i understand i would have to use a printer that has 4 extruder units ?