I am trying to find out if I can get the control board and driver board separately. I would like to print and build my own chameleon. Does anybody know if this is possible, or do I have to purchase the whole unit?
We do not sell boards... we only sell the complete assembled 3DChameleon. You can source your own by using a simple two stepper driver board with a limit switch input, like an older printer control board.
Apparently the board I was thinking of using won't work because it has a different chip. According to Chris's Basement, the Arduino uno uses the same chip. Would I be able to use an uno with a motor hat?
We do not sell boards... we only sell the complete assembled 3DChameleon. You can source your own by using a simple two stepper driver board with a limit switch input, like an older printer control board.
Bill