This post is from a suggested group
56 Views
top of page
Groups Feed
View groups and posts below.
This post is from a suggested group
3DChameleon Bear Circuits Boards
60 Views
This post is from a suggested group
K1C G-Code
After gathering the data for the MK4 G-Code where exactly would I paste this code for the K1C? I am in the printer.cfg file and not finding the best location to paste it. When I do paste it I get a warning sign.
125 Views
Jared Rementer
7 hours ago
Chat GBT helped me create the g-code to use the PA0 fan connection on the main bd. ; 3DChameleon Filament Change Trigger - PA0
; This sends a short HIGH pulse to PA0 to trigger the 3DChameleon sequence
; Make sure to pause before triggering
M83 ; Relative extrusion
G91 ; Relative positioning
G1 E-5 F100 ; Retract a bit before change
G1 Z10 F300 ; Move Z up to clear part
G1 X10 Y10 F3600 ; Move to corner
; === Trigger Pulse on PA0 ===
SET_PIN PIN=PA0 VALUE=1
G4 P250 ; Wait 250ms
SET_PIN PIN=PA0 VALUE=0
; Wait for user or 3DChameleon to finish its cycle
M0 ; Pause for manual intervention or wait
; Resume print
G92 E0
G1 E5 F100 ; Prime filament
G91
G1 Z-10 F300 ; Lower back
G90 ; Absolute positioning
Is there any particular part to the g-code this should be inserted? Any changes you would suggest?
This post is from a suggested group
84 Views
bottom of page
Send email to jeep10400@gmail.com and e-transfer fund in us dollar