Forum Posts

Ryan S
Aug 22, 2021
In Support
If I were to add another MK2 system to my existing one to get 8 colors using only the same switch, does anyone have instructions for accomplishing that setup? I'm assuming whatever that setup is from four colors to eight is the same setup for adding additional colors up to 32. Do I purchase another MK2 System or just parts of it?
0
2
70
Ryan S
Aug 22, 2021
In Support
I have done a little searching but cannot find any pictures of the 3dChameleon MK2 or MK1 installed with the RepKord Box. Does anyone know how this integrates or works? If so, I's be very grateful. I have a RepKord specifically for this MK2 kit and don't want to re-create the wheel with some over-the-top connection. Thanks in Advance
0
1
27
Ryan S
Aug 22, 2021
In Support
I have added one of the new MK2 systems to a buddy's machine. It was fast and honestly easy to install with a direct drive. Notwithstanding, I am confused with the setup though of the GCode. The printer started fine, the instructions said to change a few lines, and the 3dChameleon was homing and changing tools correctly between extruders. However, when it started printing the skirt, it was about 5mm over the bed on its Z height, and the extruder was running at the speed of sound and just skipping like mad. I am using the profiles recommended by Bill and only updated the areas requested in the G-Code. I printed before the installation of MK2 and made sure the Ender was printing correctly to rule out any issues in installing the system that could arise from a prior incorrect misconfiguration. My question would be, how do I fix my Z Height and High-speed Extruder during the printing? ALSO, I'M THE FIRST TO POST BOOYA!!!
0
2
54
Ryan S
More actions
GreenLogoNoText.png