top of page
Forum Posts
mindseye3
Mar 26, 2023
In Support
Has anyone created a version of the 3dclippy that will work on the Micro Swiss direct drive extruder? Also, it would need to work on the left hand side as my CR10-v2 homes on the left and I have my purge wipe/slide/bucket on the right hand side.
0
2
86
mindseye3
Jan 29, 2023
In Support
Bill, I do not see an option in the MK3 gcode generator for Cura as a slicer. What do I need to change to my current tool changes codes for the MK2 Cura code to enable the MK3 upgrade?
0
1
77
mindseye3
Dec 24, 2022
In Support
Anyone come up with a good Spool holder for inside an enclosure? I have a CR10-V2 and no matter how I try to hang all four rolls it creates issues with tension at the Chameleon extruders and back looping when the filament retracts.
0
1
58
mindseye3
May 17, 2022
In Support
What is the gcode or mcode for calling the active tool number? I want to cycle the filament at the end of the print to form then end and retract just like it does for the tool change.
0
3
66
mindseye3
Apr 17, 2022
In Support
Hello Bill, Thank you for responding to my other questions this weekend. After some tweaking to the code from the GCode Generator and running filament back in forth in the PTFE tubes to loosen them up a bit, I have successfully loaded the filament into the extruder. However, when trying to retract the filament after the tip is formed, the diameter of the tip is now too large to pull back through the PTFE tubes. I increased the extruder temperature to 220 hoping that might help but no luck, still can't pull it back. Any help would be greatly appreciated.
0
5
88
bottom of page