Support

I'm pretty sure in some of the videos leading up to the Mk4 release there was talk that with the Mk4 there wouldn't be a need to measure distances from Y adapter, extruder to hot-end etc. I'm frankly having difficulty with the measurements so would prefer this type of setup. How far out are we from that being released? I may simply wait if it's a reasonable time. If however I misremember/misheard about that I'll keep fighting my way through. If anyone could give me the distance from the extruder to the stock hotend on a Creality K1 that'd be helpful too. Additionally because of some physical limitations I have it's hard to get the timing for loading the filaments from Y to extruder so any suggestions or ways I can manage that would be helpful. I measured the bowden tube (23") hoping that would be close enough, but it seems like I'm still running into issues.