Ender 5 pro Bondtech DDX direct drive
I have an Ender 5 pro with a Bondtech DDX direct drive and I have installed the chameleon in the mode 3 configuration with the Y adapter attached to the back of the machine. I have used you MK3 GCode generator, placed the gcode in prusaslicer and when the machine goes to change colors it only moves to the rear and hits the normal endstop and doesnt move to the front where the chameleon endstop is. It only unloads and reloads the same filament. Any ideas?
88 Views
In mode 2 can the splitter be placed anywhere or is that only mode 3?