Prusa mini chameleon combo
I was wondering if you could provide more pictures of a prusa mini 3d chameleon set up. I followed all the instructions, but it doesn't seem to work. It hits the sensor and looks like it would change. But with my motor attached to it (from the prusa) it doesn't drive anyfilament through the system at all.
Just would love to see some close up pictures just so I know If I have everything set up the right
264 Views
I get this error. Note I have cleared the temp file location. But slicing it always creates a new temp file. And there's no way to delete it while the file is open to then export. What do you recommend? Also Do you think you could send me a picture of the prusa mini setup. In the videos I just cant see the back of printer to see the placement