3dclippy on a micro swiss direct drive extruder
Has anyone created a version of the 3dclippy that will work on the Micro Swiss direct drive extruder?
Also, it would need to work on the left hand side as my CR10-v2 homes on the left and I have my purge wipe/slide/bucket on the right hand side.
139 Views
If you are still looking, check this out. I use klipper so setting the servo up wasn't too bad. But I love it.
https://www.printables.com/model/197609-filament-cutter-for-ender-3-microswiss-extruder