Feed speed
I'm still struggling to get my 3D Chameleon to operate properly. Yesterday, I decided to start over configuring PrusaSlicer, closely following the Chris's Basement video 3D Chameleon - Part 3 - Your First Print. In it, he instructed me to create a script to measure the feed speed of the 3D Chameleon. His results were 34.5mm per second. My results, on the other hand came out to only 17mm per second! Is there a method to improve the speed of the 3D Chameleon feed?
Thanks!
85 Views
Well, I took my 3D Chameleon apart again today only to discover my feed gears were still slightly off. I've alligned them again, checked and rechecked. They're right now. I ran a test on each port and they all worked correctly. I was also able to measure the feed at the source and all four feed exactly 350mm in 10 seconds. So 35mm per second and 2100 to set the extruder load speed.
I was about to run the Chris's Basement test on it when my PC decided to freeze. I'm almost there! I'll try again after dinner.