Custom retract distance
Working with the new firmware on the MK3 - I see that the retract distance is fixed at ~10". I have been experimenting with a design to replace the Y adapter with a much smaller version that I want to integrate directly into the 3DClippy. This adapter only requires about 2-3" retraction after it is cut by the clippy (all 4 the same distance.) Since tip shaping is no longer required, the 1.8mm shape tube is not necessary, so a path with a little less tolerance (~2 to 2.2mm) seems to be fine. Is it possible to change this distance through any commands?
223 Views
As a side note, I'll happily upgrade the firmware for any one for free... just return yours to me and pay the $4 shipping.
Bill