Switch Placement on Ender 3 V2 Neo
I am preparing to install the 3D Chameleon onto my Ender 3 V2 Neo, and I noticed on one of the most recent videos from RMRRF that Bill had one of these wee beasties set up on the table. The switch seemed to be mounted on the far end of the x-axis where the BLTouch bed leveler would bump it as needed.
My question is, how was it mounted there? I think I can see an extra screw on the top of the housing, but I'm not sure.
56 Views
There is only a piece of 3M VHB tape holding it on... no screws needed.
Bill