top of page

Support

Public·24 members

Ender 3 Pro Extruder Jam

I'm having problems with the stock extruder on an Ender 3 Pro. The filament enters fine, but it misses the exit hole. It either curls around the tension wheel like in the picture or just jams. I've also tried replacing it with the Ender 5 extruder and have the same problem.


When I manually feed the filament I have no issues feeding it through.


Any ideas on how to fix this?




112 Views

It looks like that might just work. Tested it a few times with no jams. I'll follow up one more time once I finish getting it going. For anyone that has the same problem, a quick warning: a lot of people in the comments of that remix found the hole for the connector to be a little too small. I did as well, but was able to force thread it with some elbow grease.

About

Need help... check out this thread for advice from the exper...

Members

  • mayuri kathade
    mayuri kathade
  • Ben Conner
    Ben Conner
  • BOSS SUB
    BOSS SUB
  • Kendall Leake
    Kendall Leake
  • Lalo Puma
    Lalo Puma

For the latest information on product availability, be sure to follow us on twitter!  @3DChameleon

For more installation videos, be sure to follow us on Youtube!

  • Facebook
  • Twitter
  • YouTube

©2023 by 3D Chameleon

bottom of page