Blob vs purge tower
Just getting started with my 3d Chameleon and changing is finally happening with little effort (still need to tune a little bit). When I color change, after clippy, it goes to the back of the printer, creates a blob, and then continues to the purge tower. I have found that I always have to remove the blob or it drags over the purge tower and pull the blob and filament into the print. Once the several layers of the purge tower are gone, it requires constant removal for each color change later. Does the blob have to be done if you have you have a purge tower? Thanks
Matt
104 Views
So first initial of each color change should have a blob when set to one inch. After the change cycle of all four colors there shouldn't be a blob? Right now, the printer does a "blob" check with every color change. It moves in the back of the purge tower 3-4mm, blobs and continues to the purge tower dragging the blob with it. I'll adjust the gcode setting and see if that helps. Thanks for the response.
Matt