3D Clippy on Prusa Mini+
Hi all,
tried anyone to design a 3D Clippy (or something like that) on a Prusa Mini+? I'm testing 3D Chameleon and it works good, but after 10 min of print, it starts to have some issue with load/unload in zone of Y adapter, despite a good (or, it seems that for the first changes) tuning of Tip shaping.
A filament cut, i think, can improve this part.
More, the issue seems to be in Y adapter, where the 2 way meet.
Thankyou
87 Views
Yes, that's a requirement of our original design... the PTFE tubes must be pushed all the way into the pockets and the black rings pulled all the way out so that there is no play at all in them. Bad things happen if you don't follow those guidelines. (That's noted in all of our assembly videos.)
Bill