3d Chameleon SV06+ and Clippy & mode 2
Has anyone actually gotten this to work?
I have tried virtually all of the trouble shooting steps (the few there are) and no matter what the filament seems to not be loading far enough to reach to the printers extruder.
I load the filament (t0) in clip it using the clippy change to another filament (t1,t2,t3) so the chameleon backs itself out then when going back to (t0) it does not send enough filament thru to reach the printers extruder..
What am I missing here?
248 Views
It's not possible to use 3DClippy AND Mode 2 on that machine... the distance is just too far. The Mode 2 ONLY moves a certain distance and it can't be altered... but the 3DClippy AND the Y adapter together on that machine exceed that 10" length. Just follow the guide I posted above and it will add the 2nd and 3rd button press to unload and then reload the new filament. That is the only difference between the two modes... one moves exactly 10 inches... the other moves for however long you're pressing the button. If you copy that block into the gcode right below the button press logic, it will go ahead and press it a second and third time... that's the only thing that is needed to go to Mode 3. Bill