upgraded to BondTech BMG Extruder and Tip shapes are very stringy now? (shaped with code and smaller ptfe tube)
Hello!
I upgraded my BMG clone to a real BondTech BMG and now my tips are stringy and getting jammed in the Y adapter. Both of these were just formed by the GCode and the smaller PTFE Tube from the kit and the coupler.
however -- are these supposed to be so noisy as well during the tip shaping procedure? My BMG Clone was very loud during that GCode, but the real BMG makes an awful sounding grinding noise during the fast tip shaping too. Not sure if it's related. I updated my Esteps to 415 in my printer software like BondTech suggested and the rest of the printer prints fine, just the tip shaping parts are weird now, were better with the clone.
82 Views
My F speeds are actually already capped at 4000 at the highest for that section (GCode Generator is the same), does it still need to be even lower still? the same 1/3 rule apply or is the math directly proportional to the old/new Estep ratio?