T0 Loading to less and unloding to far
Hi i have a issue (pretty shure that i am doing something wrong).
Following scenario:
Each Filament is excactly 1" before the y-adapter.
I am doing 5 Pulses (controlled by gpio 5*500ms) to Home and Load T0.
Pressing for exactly 6000ms
T0 Will be loaded and feeded to point "x"
Sending 2 Pulses to switch to T2
Pressing for 6000ms,
T0 will be unloaded and retracted back about 2 inches before the y-adapter
Relesing the "gpio-button"
Pressing again for 6000ms.
T1 is feeded to position X+1"
As result of this the filament of t0 is creeping up the ptfe
does someone know what i am doing wrong?
80 Views
#2 has me confused… Does this mean that the upper entries should be about 1" back and the lower entries somewhere around 2.5"?