Getting Started

I haven’t seen any pictures yet showing the k1 (not max) 3d clippy mounted on the servo so i figured this may help someone. I went with the 25kg cutter so I didn’t have to use the buck converter. I could still if I wanted to increase the voltage. It works fine the way it is. The servo came with an assortment of horns. I just followed what bill said in the upgrade section about cutting off 3 of the 4 horns. It works well. Cuts no problem. It was a little finicky though. You have to the the horn in the same position as I do or else it jams. I also had to cut down a few mm of the part where the blade fits into or else I didn’t get the full movement and the servo would just jam up.