changing firmware
ok so i think i will have to change the firmware with my vyper because i dont see nothing in cura for a tool change gcode in my settings, Also the bracket for the tube i dont have that same setup for my vyper,
165 Views
top of page
Getting Started
Public·113 members
bottom of page
No... you never need to change the firmware with the 3D Chameleon, we're do nothing with it. You can't use a previously created Vyper profile with Cura because they didn't define it with 4 extruders and they don't allow you to change the number of extruders. You can start with out Ender 3 profile and simply update the Tool Change GCode and Start and End Gcode, and it'll work just fine. You can also tweak the settings for your particular extruder by copying them from the actual Vyper profile.
Start with this profile, for example: https://1drv.ms/u/s!Av2Y103sCRZ3mtBbi1g1OXKWl2fLDQ