top of page

Getting Started

Public·111 members

3D Auto Clippy Slot cleanup

Are you struggling to get a smooth slot for the blade on your Auto Clippy like I have, so it doesn't bind? I found a trick that might help someone else.


Using a thin feeler gauge, in this case a 0.70mm gauge, I used my soldering hot air gun to heat it up (around 662 degrees), and then worked it through the slot several times. I did this until it worked through smoothly and left a decent slot. The blade now slides through smoothly and does not bind.



174 Views
wjsteele
wjsteele
May 15

I recommend orienting the print so the slot is printed vertically.


Bill

About

New to the 3D Chameleon... check out this thread for tips on...

Members

  • Precise Signs
    Precise Signs
  • Emma Gruyé
    Emma Gruyé
  • Kendall Leake
    Kendall Leake
  • Tim A.
    Tim A.

For the latest information on product availability, be sure to follow us on twitter!  @3DChameleon

For more installation videos, be sure to follow us on Youtube!

  • Facebook
  • Twitter
  • YouTube

©2023 by 3D Chameleon

bottom of page