Just following up with this one as i have recently picked a 3dChameleon up. Is the SV06 profile for prusa slicer fine to use for the sv06 plus? will there be any changes needed to the gcode initial location of button line? I think i grasp the installation process for swapping the back left bearing holder.
About
New to the 3D Chameleon... check out this thread for tips on...
Just following up with this one as i have recently picked a 3dChameleon up. Is the SV06 profile for prusa slicer fine to use for the sv06 plus? will there be any changes needed to the gcode initial location of button line? I think i grasp the installation process for swapping the back left bearing holder.