To see this working, head to your live site.

Unload filament on print fail/cancel

I have the 3D Chameleon Mk4 setup on a Bambu P1S and it is working great.

The reset process is cumbersome when I cancel a print though.

Is there a place in Bambu Studio I can add a script or some gcode to perform the 6-pulse filament unload magic?

2 comments

2 Comments

Sep 28

What I would do is take your end GCode and save it as a file by itself that you can run it.

Bill

Sep 28

Replying to

I will give that a shot. It will earn a permanent spot on the sdcard if it works :) Thank you, sir!