Hello guys,
Any tips for printing cam of mk4, I am having some troubles fitting the cam and motor shaft even before putting the bearing. After putting on the bearing it was so much harder, I tried playing with xy_hole contour to increase hole size but just couldn't get it right. I am afraid to hammer it.
Same problem here - but solved it this way:
Perfect fit on the shaft. I use PLA (Prusa) 0.2mm layer.
Downside - bearing holder (top and bottom) needs to be adjusted (from 5,4mm to <=5,0mm) with a nail file:
We press fit them on... never use a hammer... that will damage the parts.
Bill