Help On AnkerMake M5C

I need help with the setup for the AnkerMake M5C Printer. (Not the M5)

Pictures would be greatly appreciated if anyone else has set up this printer.

Here are the things I need help with:

1. Where should I put the switch? (I am thinking by the bed or on the right gantry cover, but homing the bed would press the switch, and may mess up something)

2. How do I bypass the filament runout sensor? (Since this is the M5C, the filament sensor is inside the print head)

3. Has anyone made a 3D Clippy mount for this printer? If not, how should I?

4. When it tries to load a new filament in, the gears that are pressed together make it a little hard for the material to load. How should I fix this?

Please remember, this is the M5C, not the M5.

Thanks in advance.