So I have finally got this pretty much installed, BUT, I am at this point with the extruder wher I kind of figured my way into installing it like this in my picture. The problem is though is it seems to run reverse of what it should...? Its physically installed the stock way with the connector to the left of the machine if youre facing it. Is this correct? Also when I went to the menu to move the extruder it just wasnt working, I can reconnect it and it jumps a bit then I cant crontrol it fron the control.
Any information will help! After this I'm sure I will be asking questions on the Gcode side soon enough. Thanks!
Additional info: Ender 3 Pro, this was a direct extrusion machine I used the same motor and made it run essentially stock for the chameleon purpose.