Yes... I am working on an entirely new installation video... it should be done by this weekend... however, the installation video I currently have out there (https://youtu.be/AgWK9Uz4w_w?t=2180) at about the 36 minute time mark is very nearly identical to your Ender 3 installation. The big difference is the extruder, and you'll need this part from Thingiverse to install it: https://www.thingiverse.com/thing:4881486
The switch on the base Ender 3 is on the X axis at the right end of the arm... on the Ender 3 V2, it can be installed on the front of the Y axis.
Yes... I am working on an entirely new installation video... it should be done by this weekend... however, the installation video I currently have out there (https://youtu.be/AgWK9Uz4w_w?t=2180) at about the 36 minute time mark is very nearly identical to your Ender 3 installation. The big difference is the extruder, and you'll need this part from Thingiverse to install it: https://www.thingiverse.com/thing:4881486
The switch on the base Ender 3 is on the X axis at the right end of the arm... on the Ender 3 V2, it can be installed on the front of the Y axis.
Bill
Here's the new installation video.
https://www.youtube.com/watch?v=0Dux6tBVc_w&list=PLs1jpNL7rg7_w_ufJVqMZ4nUdiA1cg38_
thank you so much